|
- Install 6 AA batteries. See battery
compartment.
- Fill tank with Super Zero Fog-Ring Fluid
Only
- Turn power switch on. Light in fog
chamber indicates Zero Blaster in on.
- Pull pump handle to fill fog chamber
with fog. For best results a few light pumps are enough to fill the fog
chamber.
- Pull firing trigger back until the
plunger is released. Achieve rapid fire by pulling and recocking
trigger continuously.
- When the overflow tank is full, use
eye-dropper on Super Zero bottle to transfer fluid into fuel tank. Note: when there is fluid in overflow tank turning
the Blaster upside down or on side could spill fluid from the Fog
Chamber.
Caution: Do not use
in closed environments. If the fog causes skin, eye, or nasal
irritation, discontinue use. Fog may cause asthmatic reactions in
highly sensitive individuals. Adult supervision recommended. Liquid not
for internal consumption. Keep out of reach of small children.
- Install 6 AA batteries. See battery
compartment.
- Fill tank with Super Zero Fog-Ring Fluid
only
- Turn power switch on. Light in handle
indicates Zero Launcher in on.
- Push pump button to fill fog chamber with
fog. For best results a few light pumps are enough to fill the fog
chamber. Do not keep pump button depressed.
- Pull firing lever back then roll finger
off of lever allowing the plunger to strike the diaphragm. The further
back the firing lever is pulled the faster the fog rings will travel.
- When the overflow tank is full, use
eye-dropper on Super Zero bottle to transfer fluid into fuel tank. Note: excess fluid in over flow tank can spill from
Fog Chamber if Launcher is laid on side or turned upside down.
 1.
Install 6AA batteries per instructions
in battery compartment.To open Use
pencil or pen to push down battery door
latch.
2. Fill Fluid tank with Supper Zero Fluid.
3. Hold power button down . When power
is on the eyes will glow on the Wizard head. Also, the power indicator
light will glow.
When you release the power button the power will go off.
4. While holding the power button down
wait 3 to 5 seconds for the Vapor generator
to heat up ,then depress the Vapor Button.
5. If the Excess Fluid Tank is full suck out the fluid ,with the eye
droper supplied on the bottle and put the fluid back into the fuel tank
to reuse.
6. To install a Wizard Head align the Head as shown then push the neck
of the head down
and over the top of the Wizard Stick. The head is correctly seated if
the eyes glow when the
power button is depressed.
Caution: Do not use
in closed environments. If the fog causes skin, eye, or nasal
irritation, discontinue use. Fog may cause asthmatic reactions in
highly sensitive individuals. Adult supervision recommended. Liquid not
for internal consumption. Keep out of reach of small children.
To read more about
the amazing science behind Zero Toys click HERE
To read instructions
on how to make bigger and better rings click HERE
|
The Zero Blaster Manual
The
Zero Launcher Manual
